Automation Inc. EP-1 Manual de instrucciones descargar pdf (Pagina 8)

T4x-SERIES QUICKSTART GUIDE

INDICATORS AND KEYPAD BUTTON

Figure 2 - Indicators

The following LED indicators are located on the camera (Figure 2):

POWER

On – camera is connected to power

NET

On – Ethernet link is established. Blinking - data transmission

ONLINE

On – Loaded tasks will be executed based on their trigger parameters

OUT1

On – Output 1 is on

OUT2

On – Output 2 is on

OUT3

On – Output 3 is on

BUSY

LED blinks during image and flash memory access

BUTTON

Camera Reset: See Note below

To trigger the Camera Button event, press and release the button (Internal

software event trigger only)

Note: Camera Reset will restore the factory camera settings. This includes deleting all user settings on the camera

and resetting the camera’s IP Address and Mask to the factory default.

To Reset the Camera

1. Turn off power.

2. Press and hold the Camera Reset button.

3. Turn on power.

4. When all the LED indicators turn on and remain lit, release the Camera Reset button.

5. Wait approximately 30 seconds for the camera to restart.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 21 22

Sin comentarios

Automation Inc. EP-1 Manual de instrucciones Pagina 8